77 lines
2 KiB
C++
77 lines
2 KiB
C++
/*
|
|
RadioLib XBee Transparent Operation Example
|
|
|
|
This example transmits packets using XBee Transparent mode.
|
|
In Transparent mode, two XBee modules act like a Serial line.
|
|
Both modules must have the same PAN ID, and the destination
|
|
addresses have to be set properly.
|
|
|
|
IMPORTANT: Before uploading this example, make sure that the XBee modules
|
|
are running AT COORDINATOR and AT ROUTER firmware!
|
|
|
|
For full API reference, see the GitHub Pages
|
|
https://jgromes.github.io/RadioLib/
|
|
*/
|
|
|
|
// include the library
|
|
#include <RadioLib.h>
|
|
|
|
// XBee has the following connections:
|
|
// TX pin: 9
|
|
// RX pin: 8
|
|
// RESET pin: 3
|
|
XBeeSerial bee = new SerialModule(9, 8, 3);
|
|
|
|
// or using RadioShield
|
|
// https://github.com/jgromes/RadioShield
|
|
//XBeeSerial bee = RadioShield.ModuleA;
|
|
|
|
void setup() {
|
|
Serial.begin(9600);
|
|
|
|
// initialize XBee module with baudrate 9600
|
|
Serial.print(F("[XBee] Initializing ... "));
|
|
int state = bee.begin(9600);
|
|
if (state == ERR_NONE) {
|
|
Serial.println(F("success!"));
|
|
} else {
|
|
Serial.print(F("failed, code "));
|
|
Serial.println(state);
|
|
while (true);
|
|
}
|
|
|
|
// set PAN ID to 0123456789ABCDEF
|
|
Serial.print(F("[XBee] Setting PAN ID ... "));
|
|
state = bee.setPanId("0123456789ABCDEF");
|
|
if (state == ERR_NONE) {
|
|
Serial.println(F("success!"));
|
|
} else {
|
|
Serial.print(F("failed, code "));
|
|
Serial.println(state);
|
|
while (true);
|
|
}
|
|
|
|
// set destination address to the address of the second module
|
|
Serial.print(F("[XBee] Setting destination address ... "));
|
|
state = bee.setDestinationAddress("0013A200", "40A58A5D");
|
|
if (state == ERR_NONE) {
|
|
Serial.println(F("success!"));
|
|
} else {
|
|
Serial.print(F("failed, code "));
|
|
Serial.println(state);
|
|
while (true);
|
|
}
|
|
}
|
|
|
|
void loop() {
|
|
// XBeeSerial supports all methods of the Serial class
|
|
// read data incoming from Serial port and write them to XBee
|
|
while (Serial.available() > 0) {
|
|
bee.write(Serial.read());
|
|
}
|
|
|
|
// read data incoming from XBee and write them to Serial port
|
|
while (bee.available() > 0) {
|
|
Serial.write(bee.read());
|
|
}
|
|
}
|