/*
   KiteLib SX127x Transmit Example

   This example transmits packets using SX1278 LoRa radio module.
   Each packet contains up to 256 bytes of data, in the form of:
    - Arduino String
    - null-terminated char array (C-string)
    - arbitrary binary data (byte array)

   Other modules from SX127x family can also be used.
   SX1272 lora = Kite.ModuleA;
   SX1273 lora = Kite.ModuleA;
   SX1276 lora = Kite.ModuleA;
   SX1277 lora = Kite.ModuleA;
   SX1279 lora = Kite.ModuleA;
*/

// include the library
#include <KiteLib.h>

// SX1278 module is in slot A on the shield
SX1278 lora = Kite.ModuleA;

void setup() {
  Serial.begin(9600);

  // initialize SX1278 with default settings
  Serial.print(F("[SX1278] Initializing ... "));
  // carrier frequency:           434.0 MHz
  // bandwidth:                   125.0 kHz
  // spreading factor:            9
  // coding rate:                 7
  // sync word:                   0x12
  // output power:                17 dBm
  // current limit:               100 mA
  // preamble length:             8 symbols
  // amplifier gain:              0 (automatic gain control)
  int state = lora.begin();
  if (state == ERR_NONE) {
    Serial.println(F("success!"));
  } else {
    Serial.print(F("failed, code "));
    Serial.println(state);
    while (true);
  }
}

void loop() {
  Serial.print(F("[SX1278] Transmitting packet ... "));

  // you can transmit C-string or Arduino string up to
  // 256 characters long
  int state = lora.transmit("Hello World!");

  // you can also transmit byte array up to 256 bytes long
  /*
    byte byteArr[] = {0x01, 0x23, 0x45, 0x56, 0x78, 0xAB, 0xCD, 0xEF};
    int state = lora.transmit(byteArr, 8);
  */

  if (state == ERR_NONE) {
    // the packet was successfully transmitted
    Serial.println(" success!");

    // print measured data rate
    Serial.print("Datarate:\t");
    Serial.print(lora.dataRate);
    Serial.println(" bps");

  } else if (state == ERR_PACKET_TOO_LONG) {
    // the supplied packet was longer than 256 bytes
    Serial.println(" too long!");

  } else if (state == ERR_TX_TIMEOUT) {
    // timeout occured while transmitting packet
    Serial.println(" timeout!");

  }

  // wait for a second before transmitting again
  delay(1000);
}